Sailplane Construction Article Session #22
The holiday activities have been taking up most
of my time the last few days. I did finish planking the stab center section.
Today I had time to remove the landing gear from the fuselage so I could jig
up the fuselage and do a trial fit of the stab on the fuselage stab platform
structure as shown below. The fit is pretty good although the stab is
slightly tilted right tip down. After Christmas I will have to sand a little
on the left side of the fuselage stab platform structure to level up the
stab. Since tomorrow is Christmas Eve, I discontinued work on the Sailplane
altogether this evening and will start up again sometime after Christmas.
Merry Christmas to all of you guys!....................Tandy
Click Here to go to the
next page (23)....